VCT Strip & Recoat Springfield VA — Restore the Shine That Makes Your Facility Look Maintained

We assess the floor condition, measure the square footage, identify areas of heavy wear, yellowing, or finish buildup, and plan the job around your facility's schedule. VCT strip and recoat requires adequate drying time between coats — we schedule around your operations including evenings and weekends to minimize disruption. Before stripping begins, we protect walls, baseboards, and transitions, move furniture and equipment as needed, and ensure the work area is fully prepared.

We apply a professional-grade stripping solution across the entire floor surface and allow it to dwell and penetrate the old finish layers. The solution breaks down years of accumulated floor finish, wax buildup, scuff marks, and embedded soil at the chemical level before any mechanical agitation begins. We then scrub the entire floor using a floor machine to lift all loosened finish and soil from the tile surface — reaching edges and corners by hand to ensure complete coverage. Thorough stripping is the most critical step in the entire process — finish applied over incompletely stripped tile will not bond correctly and will fail prematurely.

After stripping, we neutralize the floor using a pH-neutralizing rinse that stops any remaining chemical activity from the stripper and prepares the tile surface for new finish. This step is non-negotiable — applying finish over an un-neutralized floor causes adhesion failure and premature peeling. We rinse thoroughly and allow the floor to dry completely before any finish is applied. The bare tile at this stage should be uniform in color and completely clean — if it isn't, we strip again before proceeding.

We apply commercial-grade floor finish in 3 to 5 coats depending on the floor's condition, traffic level, and your appearance standard. Each coat is applied evenly across the entire floor surface using a finish mop, allowed to dry completely before the next coat is added. Building finish in multiple thin, even coats produces a harder, more durable result than fewer thick coats — and the coat count is calibrated to the specific floor and facility rather than applied uniformly to every job. High-traffic areas like corridors and reception zones may receive additional coats for increased durability.

After the final coat cures, we conduct a thorough inspection of the entire floor — checking for even coverage, consistent sheen, and any areas that need an additional pass before the job is complete. We then walk through the results with you before considering the job done. For facilities that want to maintain results between full strip and recoat jobs, we offer scrub-and-recoat and spray buffing as standalone services that keep your floors looking professionally maintained year-round at a fraction of the full-service cost.